A Little Guidance Please.


There are many ways to make a DIY Flexor billet like using ring magnets as your primary source. . The most popular methods include using a glue gun, plywood, a soft fabric, and a jigsaw. The first step to ensure your board is strong, secure, and stable is to measure it accurately. Next, determine the span between each of the boards and the distance between the centers. To determine the right span for your board, draw a straightline on the board vertically (bearing awayfrom the wall) and place the pencil at the center. This will help you determine how big your board should be.

To begin your project, cut the plywood to fit together along the long side, and then use the soft cloth to clean any dirt, dust or debris from the edges. Lay the board horizontally and place the long side against the wall. Next, cut diagonally the board to fit diagonally against plywood. Now it’s time to secure the board together, and this can be achieved with the use of a drywall knife and screws. You may want to use nails or screws depending on how secure you want your board to be.

After you have secured the board together, you are now ready to bend it. You will need to use the drywall tool again to secure the board. Next, you will need to bend the board into an U shape using a hammer. To avoid stretching your board while you bend it you will want the knife to start at the end. To create a crease on the board, start by tracing the knife along one side of it. Once you have created a crease, run the knife across the board along the U shape until the board is level with the wall.


Leave a Reply

Your email address will not be published. Required fields are marked *